how to use capsule making machine

THE STEPS:

1. Take apart 100 capsules and put the caps and capsule bodies into two separate bowls

2. Use the Alignment Plate to load the capsule bodies

3. After you load the capsule bodies and make sure they’re all in the correct direction, connect the Spill Guard and prepare your powder

4. Use a clean metal spoon to load the powder above the capsule bodies

5. Use the spatula to evenly disperse your powder into each of the pill bodies

6. Grab your Tamper Plate and align it with the capsule bodies

7. Press down firmly to pack the powder into the capsule bodies

8. Repeat steps 5-7 until your capsule bodies are fully packed

9. Carefully dump the excess powder out of the corner of the Spill Guard into a clean separate container (I like to keep my excess powder separate from the original bag of powder)

10. Prepare your Cap Plate with the Alignment Plate and load your capsule caps

11. Make sure all your capsule caps are in the right direction

12. Connect the Middle Plate (with the grooves facing up) above the Cap Plate and be sure that the holes are aligned perfectly

13. Place the Middle Plate with the Cap Plate on top of the Body Plate and align the four screws at the corners

14. Firmly and evenly press down on the Cap Plate to join the plates and capsules together

15. Repeat step 14 several times to ensure all the capsules are fully pressed together (you want to be sure to connect them all because you don’t want to have to go back later to press the capsules together individually)

16. Remove the Cap Plate and inspect it to ensure that all the caps connected to the capsule bodies

17. Pull up on the Middle Plate

18. All your finished capsules will be suspended in the Middle Plate

19. Push out the finished capsules into a clean container

20. Inspect several capsules by gently pressing on the ends to make sure they’re fully connected

21. Add the finished capsules to a clean plastic vitamin bottle or other airtight containers (I like to save my old vitamin bottles to reuse)

22. After you finish, wash the machine and other parts with warm soapy water and a soft sponge to avoid scratching the plastic

23. Allow everything to air dry and store your machine inside a large Ziploc bag or sealed